[FIXED] v2.5.0.2 - Quality Change on a Model Relative to Factory vs Line Capacity

[Elouda]

This may not be a bug, but I strongly suspect it is.

The quality change on a model appears to be relative to the total tooled capacity of the factory, instead of the capacity of that specific line. This means that if you have a factory with several lines like the example below, with each line only around 20-30% of the total factory capacity, you can run them all at full speed and still gain quality across them all.

So in the example shown, its considering 1200/5700 instead of 1200/1200.

The expected behavior is that the quality change is relative to the tooled capacity of the line, not the tooled capacity of the factory.

Screenshot showing this and savegame attached.




  SG8f.zip (Size: 9.11 MB / Downloads: 1)

[Eric.B]

This was changed. It may need more play testing in the future.
It should also be noted that the quality rating does take into account the number of bodies and platforms also being built at the factory.

Changes are in the next update, thanks again.