Out of Alignment Table

[Arakash]

For whatever reason print screen is not capturing screenshots, and when pasted into paint it's just a black screen.

That said, When adjusting sliders to build stuff, I have been seeing words (what your lead R+D person says to you) run off the right under the side piece. Hard to explain, but it's in there. Can't remember if it's chassis, engine, or trans, I will check tonight and edit this post accordingly.

Why are you trying to paste the SC into paint?
When you press Print Screen it creates a Screenshot in the folder you installed Gearcity into.
Specifically:
Gearcity Open Beta/Gearcity/Screenshot
Where "Gearcity Open Beta" is the folder in which the exe file is located.

Edit: I just updated the out of date information in my FAQ about screenshots.