Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[FIXED]Lock Lobbying percentage not working
#5
(06-06-2014, 07:14 AM)Frankschtaldt Wrote: I clearly used % symbols. How did you get that I was discussing absolute values from that?
Because the way you worded it was extremely unclear. I was and still am confused about what you meant.
I edited my earlier post and provided a clear example of what i meant, i hope it helps explain it more.

Here is what you said:
"I ask because I thought the advertising budget lock wasn't working until I realized it was displaying 100% of the previous month. "

I interpreted this as:
You set it to $100 and 100%
Next month it was $100, "which you thought was weird until you realized it was displaying 100% of the previous month"(So $100).

Its not supposed to show 100% of the previous value, so i dont know why that is not weird to you.

Using that specific example, its not supposed to show 100% of your previous value, or $100, its supposed 100% of the current value.
So if the maximum was now $110, it should be at $110, not $100

(06-06-2014, 07:14 AM)Frankschtaldt Wrote: What I asked you was: "Has it been hovering at roughly the same amount under 100% or has it been slowly dropping?"

The reason I asked you this is because if it is slowly degrading then it is definitely not working. However if you set it at 100% but then the following turn it shows slightly lower but then consistently stays there. It could be that it is displaying the amount paid the previous turn but comparing it to the max this turn. Which doesn't mean its not working. It just means it isn't updating the way you expect it too.
I mentioned advertising because this is what it does (in my current game at least). I set my newspaper advertising budget at 100% and lock it. But from the next turn, until I change it again the slider always shows the same small amount below max because it is updating expenditure at a different time to when it updates what the new maximum value it.

I apologize for being vague, i edited my previous post several times to try and provide a clear example of this. I believe i have now done so.
Please read it again and it might make a lot more sense.
Reply


Messages In This Thread
RE: Lock Lobbying percentage not working - by Arakash - 06-06-2014, 07:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)