GearCity 1.18 Progress

[Frankschtaldt]

Curious question, how many decimal places is the game going to let us go down to when entering bore and stroke?

I haven't touched anything for decimal points, it still works off whole mm numbers.

Is it too late to allow one or two?
An overwhelming majority of rl engines have at lease one measurement with at least one decimal place and I think a lot of people are going to want to try and copy them.
Probably not a huge deal if you can't. It would just be nice.

It may be possible at a later date, however dealing with floats can be a bit of a pain in the rear. So I would prefer to get them as integers. But as always, if there is enough demand for it, it can change.

Could you treat them as an integer by having two fields, one where you enter you whole numbers and another where you enter you x/10 or x/100 value? Or is that even worse?