Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[FIXED] 2.4.0.0 - Duplicate Maximum Engine Width slider
#1
On the R&D Chassis Design screen, when opening the Frame Dimensions there are two sliders for Maximum Supported Engine Width and no slider for Maximum Supported Engine Height.
Reply
#2
One of them is likely for the height, the text label was likely not changed.

If they both only do width, let me know!
"great writers are indecent people, they live unfairly, saving the best part for paper.
good human beings save the world, so that bastards like me can keep creating art, become immortal.
if you read this after I am dead it means I made it." ― Charles Bukowski
Reply
#3
The bottom slider always starts at zero and doesn't seem to impact anything.
Reply
#4
I'm fairly sure it was working when I last used it. Might have been a regression. In the mean time, a work around is to use the assisted designer to set the height, then bounce back to the advance window to finish the chassis design.
"great writers are indecent people, they live unfairly, saving the best part for paper.
good human beings save the world, so that bastards like me can keep creating art, become immortal.
if you read this after I am dead it means I made it." ― Charles Bukowski
Reply
#5
I was able to fix this one, and I'll be in the next update.

Thanks again!
"great writers are indecent people, they live unfairly, saving the best part for paper.
good human beings save the world, so that bastards like me can keep creating art, become immortal.
if you read this after I am dead it means I made it." ― Charles Bukowski
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)