I would like to have the cost("Design Project Cost") of design sliders that only effect design cost rather than unit cost balanced a bit. At the moment, i cant see much reason not to max them all in any situation other than to reduce the design time.(which doesn't come up often)
I think i suggested in another thread that a possible solution for this was to have most or all of the sliders effect unit cost in some way(many dont atm), but i think i have a better idea for it which ill talk about below.
Suggestion:
I think the "Design project Cost" of design sliders that don't effect unit cost should be increased, but only when they are set close to maximum.
You could even have a red line, which would represent the point at which the costs increase dramatically. Going over this line could just cost extra, or it could involve a chance of waste or failure(making it worse than it would be normally) depending on the skill of your team.
Edit: Maybe "Overdesign" is something to call it? i don't know.
Exceptions:
I still think the costs of the design sliders, when set to middle and low, should perhaps be left where they are, in order to preserve the current costs/balance of designing a vehicle when starting out.
Changing them would force you to spend extra time balancing the entire thing out.
Example:
As a crude example (Note: not real cash numbers)
The middle might cost 20,000
Max to the left might cost 10,000
Half way to the left might cost 30,000
Above the red line and Max to the right (best positive effect) might cost 80,000-100,000
Comments:
This would give you a lot of motivation to make a hard decision on how much you really want to spend on component/vehicle design. In most cases, you would really only want to max one of them, unless you had a lot of money to throw at design.
Maxing all of them would be possible for rich players, but still carrying a component of risk.
I just made a basic representation in paint of what i suggest would look like(obviously its very basic looking), using the red line i suggested above.
Thoughts?
I think i suggested in another thread that a possible solution for this was to have most or all of the sliders effect unit cost in some way(many dont atm), but i think i have a better idea for it which ill talk about below.
Suggestion:
I think the "Design project Cost" of design sliders that don't effect unit cost should be increased, but only when they are set close to maximum.
You could even have a red line, which would represent the point at which the costs increase dramatically. Going over this line could just cost extra, or it could involve a chance of waste or failure(making it worse than it would be normally) depending on the skill of your team.
Edit: Maybe "Overdesign" is something to call it? i don't know.
Exceptions:
I still think the costs of the design sliders, when set to middle and low, should perhaps be left where they are, in order to preserve the current costs/balance of designing a vehicle when starting out.
Changing them would force you to spend extra time balancing the entire thing out.
Example:
As a crude example (Note: not real cash numbers)
The middle might cost 20,000
Max to the left might cost 10,000
Half way to the left might cost 30,000
Above the red line and Max to the right (best positive effect) might cost 80,000-100,000
Comments:
This would give you a lot of motivation to make a hard decision on how much you really want to spend on component/vehicle design. In most cases, you would really only want to max one of them, unless you had a lot of money to throw at design.
Maxing all of them would be possible for rich players, but still carrying a component of risk.
I just made a basic representation in paint of what i suggest would look like(obviously its very basic looking), using the red line i suggested above.
Thoughts?
